Re: zone router


Subject: Re: zone router
From: alan premselaar (alien@12inch.com)
Date: Thu Mar 22 2001 - 12:12:33 EST


Chad,

  Once you make a change to your appletalk network like that, you'll need to
either a) reboot your macs, or b) open up the appletalk control panel on
each of them... at which point it should tell you that your appletalk
network setting is no longer valid and re-probe the ethernet device for
zones, etc. In some cases, i've had to switch the appletalk from the
ethernet device to the printerport (or something else) and back before it
would recognize the new zones.

alan

At 11:26午前 -0500 3.22.01, Chad Cunningham wrote:
>Hi,
>
>I am trying to replace a Solaris box running CAP with a linux box running
>netatalk. I can't seem to get zones to work properly under the new
>netatalk setup. My atalkd.conf looks like
>
>eth0 -router -phase 2 -net 0-65534 -addr 257.249 -zone "Staff" -zone "RTL"
>-zone "Faculty" -zone "EMPT" -zone "Public"
>
>It seems happy with this, the atalkd.conf doesn't get overwritten when I
>start up and I can use getzones and they all show up. However, none of the
>macs recognize any zones. Any idea why this might be?
>
> --
>
>Chad Cunningham
>ccunning@math.ohio-state.edu
>
>"Well, once again my friend, we find that science is a two-headed beast. One
>head is nice, it gives us aspirin and other modern conveniences,...but the
>other head of science is bad! Oh beware the other head of science, Arthur, it
>bites!"

----
  there's nothing like the undying sense of reliability provided by modern 
technology.
----
alan premselaar
alien@12inch.com
www.12inch.com



This archive was generated by hypermail 2b28 : Sun Oct 14 2001 - 03:04:35 EDT